Openflow Versions - Lenovo RackSwitch G8264 Application Manual

OpenFlow Versions

264
G8264 Application Guide for ENOS 8.4
The RackSwitch G8264 can be configured to run either version 1.0 or version 1.3 of
the OpenFlow standard. By default, the switch uses OpenFlow 1.0. To shift
between versions, use the following commands:
RS G8264(config)# boot openflow v1

The switch will run OpenFlow 1.0 after reboot. This version does not support
the use of MPLS‐based flows (See "Flow Tables" on page
portchannels, or static LACP LAGs in OpenFlow instances (see "Configuring
OpenFlow" on page
RS G8264(config)# boot openflow v13

The switch will run OpenFlow 1.3 after reboot. This version does not support
emergency flow tables (see "Emergency Mode" on page
OpenFlow 1.3 includes (but not limited to) the following key features:
 Layer 3 MPLS
 Static portchannels and static LACP LAGs
 MAC address/IP address masking
 Flexible Table Miss and Fail Secure
 40Gb support
 Static CLI for Flow Programming
 OpenFlow Groups
 FDB aging timer
 OpenFlow 1.0 backwards compatibility
283).
266), groups, static
276).