Example 3: Auto-Vlan Mode; Example 4: Tunnel Mode - Lenovo RackSwitch G8264 Application Manual

Example 3: Auto-VLAN Mode

1. Configure port 1 as server port:
2. Turn on UFP.
3. Configure port 1 as UFP.
4. Configure virtual port.
5. Configure vPort default VLAN.
6. Configure vPort auto mode.
7. Specify QoS parameters for the vPort.
8. Enable the vPort.

Example 4: Tunnel Mode

1. Configure port 1 as a UFP server port.
2. Turn on UFP.
424
G8264 Application Guide for ENOS 8.4
G8264(config)# system server­ports port 1
RS G8264(config)# ufp enable
G8264(config)# ufp port 1 enable
Warning: "Tagging/Trunk­mode" is enabled on UFP port 1
G8264(config)# ufp port 1 vport 1
G8264(config_ufp_vport)# network default­vlan 100
G8264(config_ufp_vport)# network mode auto
Note: VLAN is dynamically added by 802.1Qbg.
G8264(config_ufp_vport)# qos bandwidth min 25 (in percentage)
G8264(config_ufp_vport)# qos bandwidth max 100 (in percentage)
G8264(config_ufp_vport)# enable
G8264(config_ufp_vport)# exit
Following is an example configuration of UFP vPorts in tunnel mode.
G8264(config)# system server­ports port 1
G8264(config)# ufp enable