Setup Part 2: Port Configuration
1. Select whether you will configure VLANs and VLAN trunk mode/tagging for
2. Select the port to configure, or skip port configuration at the prompt:
3. Configure Gigabit Ethernet port flow parameters.
4. Configure Gigabit Ethernet port autonegotiation mode.
5. If configuring VLANs, enable or disable VLAN trunk mode/tagging for the port.
72
G8264 Application Guide for ENOS 8.4
Note: When configuring port options for your switch, some prompts and options
may be different.
ports:
Port Config:
Will you configure VLANs and VLAN Tagging/TrunkMode for ports? [y/n]
If you wish to change settings for VLANs, enter y, or enter n to skip VLAN
configuration.
Note: The sample screens that appear in this document might differ slightly from
the screens displayed by your system. Screen content varies based on the firmware
versions and options that are installed.
If you wish to change settings for individual ports, enter the number of the port
you wish to configure. To skip port configuration, press <Enter> without specifying
any port and go to "Setup Part 3: VLANs" on page
The system prompts:
Gig Link Configuration:
Port Flow Control:
Current Port EXT1 flow control setting: both
Enter new value ["rx"/"tx"/"both"/"none"]:
Enter rx to enable receive flow control, tx for transmit flow control, both to
enable both, or none to turn flow control off for the port. To keep the current
setting, press <Enter>.
If you selected a port that has a Gigabit Ethernet connector, the system prompts:
Port Auto Negotiation:
Current Port autonegotiation: on
Enter new value ["on"/"off"]:
Enter on to enable port autonegotiation, off to disable it, or press <Enter> to keep
the current setting.
If you have selected to configure VLANs back in Part 1, the system prompts:
Port VLAN tagging/trunk mode config (tagged/trunk mode port can be a member
of multiple VLANs)
Current VLAN tagging/trunk mode support: disabled
Enter new VLAN tagging/trunk mode support [d/e]:
74.