Enabling or Disabling LLDP
Global LLDP Setting
Transmit and Receive Control
630
G8264 Application Guide for ENOS 8.4
Follow the instructions in this section to enable and disable LLDP.
By default, LLDP is enabled on the G8264. To turn LLDP on or off, use the
following command:
RS G8264(config)# [no] lldp enable
The G8264 can also be configured to transmit or receive LLDP information on a
port‐by‐port basis. By default, when LLDP is globally enabled on the switch, G8264
ports transmit and receive LLDP information (see the tx_rx option in the
following example). To change the LLDP transmit and receive state, the following
commands are available:
RS G8264(config)# interface port 1
RS G8264(configif)# lldp adminstatus tx_rx
RS G8264(configif)# lldp adminstatus tx_only
RS G8264(configif)# lldp adminstatus rx_only
RS G8264(configif)# no lldp adminstatus
RS G8264(configif)# exit
To view the LLDP transmit and receive status, use the following commands:
RS G8264(config)# show lldp port
RS G8264(config)# show interface port <n> lldp
(Turn LLDP on or off globally)
(Select a switch port)
(Transmit and receive LLDP)
(Only transmit LLDP)
(Only receive LLDP)
(Do not participate in LLDP)
(Exit port mode)
(status of all ports)
(status of selected port)