Configuring A Routed Port; Configuring Ospf On Routed Ports - Lenovo RackSwitch G8264 Application Manual

Configuring a Routed Port

1. Enter the interface configuration mode for the port.
2. Enable routing.
3. Assign an IP address.
4. (Optional) Enable a Layer 3 routing protocol.

Configuring OSPF on Routed Ports

456
G8264 Application Guide for ENOS 8.4
Note: Use only the ISCLI to configure routed ports. Configurations using the BBI
are not supported. Configurations made using SNMP cannot be saved or applied.
Note: You cannot configure a management port to be a routed port.
Following are the basic steps for configuring a routed port:
RS G8264(config)# interface port <port number>
Note: You must enter only one port number. If you need to change multiple ports
to routed ports, repeat the configuration steps for each port.
RS G8264(config­if)# no switchport
RS G8264(config­if)# ip address <IP address> <Subnet Mask> enable
RS G8264(config­if)# ip {<ospf>|<pim>|<rip>}
Note: Configure the Layer 3 routing protocol‐related parameters in the interface
configuration mode.
The following OSPF configuration commands are supported on routed ports:
RS G8264(config­if)# ip ospf ?
area Set area index
cost Set interface cost
dead­interval Set dead interval in seconds or milliseconds
enable Enable OSPF for this interface
hello­interval Set hello interval in seconds or milliseconds
key Set authentication key
message­digest­key Set MD5 key ID
passive­interface Enable passive interface
point­to­point Enable point­to­point interface
priority Set interface router priority
retransmit­interval Set retransmit interval in seconds
transit­delay Set transit delay in seconds
See Chapter 35, "Open Shortest Path First," for details on the OSPF protocol and its
configuration.
OSPFv3 cannot be configured on routed ports.