Vmready Information Displays; Local Ve Information - Lenovo RackSwitch G8264 Application Manual

VMready Information Displays

Local VE Information

360
G8264 Application Guide for ENOS 8.4
The G8264 can be used to display a variety of VMready information.
Note: Some displays depict information collected from scans of a VMware vCenter
and may not be available without a valid vCenter. If a vCenter is assigned (see
"Assigning a vCenter" on page
to two minutes after the switch boots or when VMready is first enabled. Also, any
major changes made through the vCenter may take up to two minutes to be
reflected on the switch unless you force an immediate vCenter scan (see "vCenter
Scans" on page 354.
A concise list of local VEs and pre‐provisioned VEs is available with the following
ISCLI privileged EXEC command:
RS G8264# show virt vm
IP Address VMAC Address Index Port VM Group (Profile)
Check status
­­­­­­­­­­­­­­­­ ­­­­­­­­­­­­­­­­­ ­­­­­ ­­­­­­­­ ­­­­­­­­­­­­­­­­­­
­­­­­­­­­­­­
0.0.0.0 00:50:56:55:47:0c 5 17.3
~0.0.0.0 00:50:56:b3:1e:7b 2 17.3 1 test
~0.0.0.0 00:50:56:b3:1f:16 1 17.3 1 test
~0.0.0.0 00:50:56:b3:2c:b9 4 18 2
~0.0.0.0 00:50:56:b3:5f:32 3 18 1 test
~0.0.0.0 00:50:56:b3:69:5a 0 19.3 1 test
VMReady ports: 17­21
Number of entries: 6
~ indicates inactive VMs
0.0.0.0 indicates IP address not yet available
Note: The Index numbers shown in the VE information displays can be used to
specify a particular VE in configuration commands.
353), scan information might not be available for up