Task 2: Configure Vlag Peer 2 - Lenovo RackSwitch G8264 Application Manual

13. Globally enable VLAG
14. Verify the completed configuration:
Task 2: Configure VLAG Peer 2
1. Configure VLAG tier ID and enable VLAG globally.
2. Configure appropriate routing.
3. Configure a server‐facing interface.
4. Turn on VRRP and configure the Virtual Interface Router.
5. Configure the ISL ports and place them into a port LAG:
© Copyright Lenovo 2016
RS G8264(config)# vlag enable
# show vlag information
The VLAG peer (VLAG Peer 2) must be configured using the same ISL aggregation
type (dynamic or static), the same VLAN for VLAG and VLAG ISL ports, and the
same STP mode and Tier ID used on VLAG Switch 1.
For each corresponding VLAG on the peer, the port LAG type (dynamic or static),
VLAN, and STP mode and ID must be the same as on VLAG Switch 1.
RS G8264(config)# vlag tier­id 10
RS G8264(config)# vlag enable
RS G8264(config)# router ospf
RS G8264(config­router­ospf)# area 1 area­id 0.0.0.1
RS G8264(config­router­ospf)# enable
RS G8264(config­router­ospf)# exit
Although OSPF is used in this example, static routing could also be deployed.
RS G8264(config)# interface ip 3
RS G8264(config­ip­if)# ip address 10.0.1.11 255.255.255.0
RS G8264(config­ip­if)# vlan 100
RS G8264(config­ip­if)# exit
RS G8264(config)# router vrrp
RS G8264(config­vrrp)# enable
RS G8264(config­vrrp)# virtual­router 1 virtual­router­id 1
RS G8264(config­vrrp)# virtual­router 1 interface 3
RS G8264(config­vrrp)# virtual­router 1 address 10.0.1.100
RS G8264(config­vrrp)# virtual­router 1 enable
RS G8264(config)# interface port 4­5
RS G8264(config­if)# switchport mode trunk
RS G8264(config­if)# lacp mode active
RS G8264(config­if)# lacp key 2000
RS G8264(config­if)# exit
Chapter 12: Virtual Link Aggregation Groups
225