Lenovo RackSwitch G8264 Application Manual page 516

6. Configure IGMP Relay.
Switch C Configuration
1. Configure VLANs.
2. Configure IP interfaces with IPv4 addresses and assign VLANs.
3. Configure STP.
4. Configure LACP dynamic LAG (portchannel).
516
G8264 Application Guide for ENOS 8.4
RS G8264(config)# ip igmp enable
RS G8264(config)# ip igmp relay vlan 2,3
RS G8264(config)# ip igmp relay mrouter 1 address 5.5.5.5 enable
RS G8264(config)# ip igmp relay mrouter 2 address 5.5.5.6 enable
RS G8264(config)# ip igmp relay enable
RS G8264(config)# vlan 2
RS G8264(config­vlan)# no flood
RS G8264(config­vlan)# exit
RS G8264(config)# vlan 3
RS G8264(config­vlan)# no flood
RS G8264(config­vlan)# exit
RS G8264(config)# vlan 2,3,5
RS G8264(config­vlan)# interface port 1­5
RS G8264(config­if)# switchport access vlan 2
RS G8264(config­if)# interface port 6,7
RS G8264(config­if)# switchport access vlan 5
RS G8264(config­if)# exit
RS G8264(config)# interface ip 2
RS G8264(config­ip­if)# ip address 2.2.2.30 enable
RS G8264(config­ip­if)# vlan 2
RS G8264(config­ip­if)# exit
RS G8264(config)# interface ip 3
RS G8264(config­ip­if)# ip address 5.5.5.30 enable
RS G8264(config­ip­if)# vlan 5
RS G8264(config­ip­if)# exit
RS G8264(config)# ip gateway 2 address 2.2.2.20 enable
RS G8264(config)# interface port 5,6,7
RS G8264(config­if)# spanning­tree portfast
RS G8264(config­if)# shutdown
RS G8264(config­if)# no shutdown
RS G8264(config­if)# exit
RS G8264(config)# interface port 1,2
RS G8264(config­if)# lacp key 400
RS G8264(config­if)# lacp mode active
RS G8264(config­if)# exit