Belt Dressing Notice; Brake Fluid Effects On Paint And Electrical Components Notice; Component Fastener Tightening Notice; Fastener Notice - Suzuki XL7 2007 Service Manual

00-3 Precautions:

Belt Dressing Notice

CAUTION
!
Do not use belt dressing on the drive belt.
Belt dressing causes the breakdown of the
composition of the drive belt. Failure to
follow this recommendation will damage the
drive belt.
Brake Fluid Effects on Paint and Electrical
Components Notice
CAUTION
!
Avoid spilling brake fluid onto painted
surfaces, electrical connections, wiring, or
cables. Brake fluid will damage painted
surfaces and cause corrosion to electrical
components. If any brake fluid comes in
contact with painted surfaces, immediately
flush the area with water. If any brake fluid
comes in contact with electrical connections,
wiring, or cables, use a clean shop cloth to
wipe away the fluid.
Clean, Dry, Low Pressure Gas Source
Notice
CAUTION
!
Use the EVAP Pressure/Purge Diagnostic
Station J 41413 in order to provide a clean,
dry, low pressure gas source. Do not
substitute any other pressurized gas source.
Damage may result to the EVAP system.
Clearcoat/Ultraviolet Screeners Notice
CAUTION
!
Removing more than 0.5 mils of the clearcoat
can result in early paint failure. The clearcoat
contains ultraviolet screeners. Do not finesse
sand more than what is required to remove
the defect.

Component Fastener Tightening Notice

CAUTION
!
Replacement components must be the
correct part number for the application.
Components requiring the use of the thread
locking compound, lubricants, corrosion
inhibitors, or sealants are identified in the
service procedure. Some replacement
components may come with these coatings
already applied. Do not use these coatings
on components unless specified. These
coatings can affect the final torque, which
may affect the operation of the component.
Use the correct torque specification when
installing components in order to avoid
damage.

Fastener Notice

CAUTION
!
Use the correct fastener in the correct
location. Replacement fasteners must be the
correct part number for that application.
Fasteners requiring replacement or fasteners
requiring the use of thread locking
compound or sealant are identified in the
service procedure. Do not use paints,
lubricants, or corrosion inhibitors on
fasteners or fastener joint surfaces unless
specified. These coatings affect fastener
torque and joint clamping force and may
damage the fastener. Use the correct
tightening sequence and specifications when
installing fasteners in order to avoid damage
to parts and systems.
Machined Surface Damage Notice
CAUTION
!
Do not nick, scratch or damage the sealing
surface. The sealing surface is a machined
surface. Damage to the machined surface
can cause leakage.