Installation And Initial Configuration - Cisco TelePresence Administrator's Manual

Device Provisioning
The Device Provisioning option key allows VCS to provision endpoints with configuration information on
request and to supply endpoints with phone book information. (Endpoints including Movi / Jabber Video, E20,
and the EX and MX Series can request to be provisioned.) All configuration and phone book information is
managed in TMS. The data is then transferred to the VCS, from where it is distributed to endpoint clients
through the Provisioning Server running on the VCS.
See TMS provisioning and
configure provisioning.
Dual Network Interfaces
The Dual Network Interfaces option enables the LAN 2 Ethernet port on the VCS Expressway, allowing you
to have a secondary IP address for your VCS.
This option also includes support for deployments where a VCS Expressway is located behind a static NAT
device, allowing it to have separate public and private IP addresses.
This configuration is intended for high-security deployments where the VCS Expressway is located in a DMZ
between two separate firewalls on separate network segments.
Virtual appliance support
The VCS can run on VMware on Cisco UCS C200 M2, UCS C210 M2 or UCS B200 M2 servers.
n
See VCS Virtual machine deployment guide

Installation and initial configuration

Full installation and initial configuration instructions for the VCS are contained in
Cisco VCS Administrator Guide (X7.2)
TMS Provisioning Extension deployment guide
for more information about installing a VCS on VMware.
Introduction
for more information about how to
VCS Getting Started
Page 15 of 498
Guide.