Cisco TelePresence Administrator's Manual page 434

Reference material
Zones LocalZone DefaultSubZone Authentication Mode:
<DoNotCheckCredentials/TreatAsAuthenticated/CheckCredentials>
Controls how the VCS authenticates incoming messages from this subzone and whether they are subsequently
treated as authenticated, unauthenticated or are rejected. The behavior varies for H.323 messages, SIP
messages that originate from a local domain and SIP messages that originate from non-local domains.
Default: DoNotCheckCredentials
Example: xConfiguration Zones LocalZone DefaultSubZone Authentication Mode:
DoNotCheckCredentials
Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call to or from an endpoint in the Default Subzone (applies
only if the mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Limit:
1920
Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in the Default
Subzone.
NoBandwidth: no bandwidth available. No calls can be made to or from the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Mode:
Limited
Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within the Default Subzone
(applies only if the mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Limit:
1920
Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within the Default
Subzone.
NoBandwidth: no bandwidth available. No calls can be made within the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Mode:
Limited
Zones LocalZone DefaultSubZone Bandwidth Total Limit: <1..100000000>
Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth Total Limit: 500000
Zones LocalZone DefaultSubZone Bandwidth Total Mode: <Limited/Unlimited/NoBandwidth>
Determines whether the Default Subzone has a limit on the total bandwidth being used by its endpoints at any
one time.
NoBandwidth: no bandwidth available. No calls can be made to, from, or within the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth Total Mode: Limited
Cisco VCS Administrator Guide (X7.2) Page 434 of 498