Installation And Initial Configuration - Cisco TelePresence Administrator's Manual

Introduction
See TMS provisioning and Provisioning deployment guide for more information about how to configure
provisioning.
Dual Network Interfaces
The Dual Network Interfaces option enables the LAN 2 Ethernet port on the VCS Expressway, allowing you
to have a secondary IP address for your VCS.
This option also includes support for deployments where a VCS Expressway is located behind a static NAT
device, allowing it to have separate public and private IP addresses.
This configuration is intended for high-security deployments where the VCS Expressway is located in a DMZ
between two separate firewalls on separate network segments.
Virtual appliance support
The VCS can run on VMware on Cisco UCS C200 M2 and UCS C210 M2 servers.
n

Installation and initial configuration

Full installation and initial configuration instructions for the VCS are contained in VCS Getting Started Guide.
Cisco VCS Administrator Guide (X7.1) Page 16 of 479