Links And Pipes; Configuring Links; Default Links - Cisco TelePresence Administrator's Manual

Links and pipes

Configuring links

Links connect local subzones with other subzones and zones. For a call to take place, the endpoints involved
must each reside in subzones or zones that have a link between them. The link does not need to be direct;
the two endpoints may be linked via one or more intermediary subzones.
Links are used to calculate how a call is routed over the network and therefore which zones and subzones are
involved and how much bandwidth is available. If multiple routes are possible, your VCS will perform the
bandwidth calculations using the one with the fewest links.
The Links page (VCS configuration > Bandwidth >
edit and delete links.
The following information is displayed:
Field Description
Name The name of the link. Automatically created links have names based on the nodes that the link is
between.
Node 1 The two subzones, or one subzone and one zone, that the link is between.
and Node
2
Pipe 1 and Any pipes that have been used to apply bandwidth limitations to the link. See
Pipe 2 for more information. Note that in order to apply a pipe, you must first have created it via the
page.
Calls Shows the total number of calls currently traversing the link.
Bandwidth Shows the total amount of bandwidth currently being consumed by all calls traversing the link.
used
You can configure up to 3000 links.
Whenever a subzone or zone is created, certain links are automatically created; see
information.

Default links

If a subzone has no links configured, then endpoints within the subzone will only be able to call other
endpoints within the same subzone. For this reason, the VCS comes shipped with a set of pre-configured
links and will also automatically create new links each time you create a new subzone.
Pre-configured links
The VCS is shipped with the Default Subzone, Traversal Subzone and Default Zone already created, and
with default links pre-configured between them as follows: DefaultSZtoTraversalSZ, DefaultSZtoDefaultZ
and TraversalSZtoDefaultZ. If the VCS is in a cluster, an additional link, DefaultSZtoClusterSZ, between the
Default Subzone and the Cluster Subzone is also established.
You can edit any of these default links in the same way you would edit manually configured links.
If any of these links have been deleted you can re-create them, either:
Cisco VCS Administrator Guide (X7.2)
Links) lists all existing links and allows you to create,
Bandwidth control
Applying pipes to links
Pipes
Default links for further
Page 223 of 498