Ip Status - Cisco TelePresence Administrator's Manual

IP status

The IP status page (Status > System >
The following information is displayed:
Field Description
IP section:
Protocol Indicates the IP protocol supported by the VCS.
IPv4: it only accepts registrations from endpoints using an IPv4 address, and will only take calls
between two endpoints or devices communicating via IPv4. It will communicate with other systems
via IPv4 only.
IPv6: it only accepts registrations from endpoints using an IPv6 address, and will only take calls
between two endpoints communicating via IPv6. It will communicate with other systems via IPv6
only.
Both: it accepts registrations from endpoints using either an IPv4 or IPv6 address, and takes calls
using either protocol. If a call is between an IPv4-only and an IPv6-only endpoint, the VCS will act as
an IPv4 to IPv6 gateway (note that this will require a traversal call license). The VCS can
communicate with other systems via either protocol.
IPv4 The IPv4 gateway used by VCS.
gateway
IPv6 The IPv6 gateway used by VCS.
gateway
Dual Indicates whether the second LAN port has been enabled. This is done by installing the Dual
Network Network Interfaces option key.
Interfaces
LAN 1 Shows the IPv4 address and subnet mask, and IPv6 address of the LAN 1 port.
LAN 2 If the Dual Network Interfaces option key has been installed, this shows the IPv4 address and subnet
mask, and IPv6 address of the LAN 2 port.
DNS section:
Server The IP addresses of each of the DNS servers that are queried when resolving domain names. Up to
1..5 5 DNS servers may be configured.
address
Domain Specifies the name to be appended to the host name before a query to the DNS server is executed.
The IP settings can be configured via the
The Dual network interfaces option is enabled by the addition of the corresponding option key.
Cisco VCS Administrator Guide (X7.2)
IP) shows the current IP settings of the VCS.
IP page.
Overview and status information
Page 28 of 498