Cisco TelePresence Administrator's Manual page 437

Reference material
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Inter Mode:
<Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone.
NoBandwidth: no bandwidth available. No calls can be made to or from this subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Inter Mode:
Limited
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Intra Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within this subzone (applies only if
the mode is set to Limited).
Default: 1920
Example: Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Intra Limit: 1920
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Intra Mode:
<Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone.
NoBandwidth: no bandwidth available. No calls can be made within this subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Intra Mode:
Limited
Zones LocalZone SubZones SubZone [1..1000] Bandwidth Total Limit: <1..100000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if the mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth Total Limit: 500000
Zones LocalZone SubZones SubZone [1..1000] Bandwidth Total Mode: <Limited/Unlimited/NoBandwidth>
Determines whether this subzone has a limit on the total bandwidth of calls being used by its endpoints at any
one time.
NoBandwidth: no bandwidth available. No calls can be made to, from, or within this subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth Total Mode: Limited
Zones LocalZone SubZones SubZone [1..1000] Name: <S: 0, 50>
Assigns a name to this subzone.
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Name: "BranchOffice"
Zones LocalZone SubZones SubZone [1..1000] Registrations: <Allow/Deny>
Controls whether registrations assigned to this subzone are accepted.
Default: Allow
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Registrations: Allow
Cisco VCS Administrator Guide (X7.2) Page 437 of 498