Configuring The Cisco Vcs As A Traversal Client - Cisco TelePresence Administrator's Manual

Grey Headline (continued)

Configuring the Cisco VCS as a traversal client

To enable your VCS to act as a traversal client on behalf of its endpoints and neighbor gatekeepers,
you must create a connection between it and a traversal server (e.g. a VCS Expressway or Border
Controller).
You do this by adding a new traversal client zone on the VCS client and configuring it with the details
of the traversal server.
To add a new traversal client zone:
•
VCS configuration > Zones.
You are taken to the Zones page.
Click New.
You are taken to the Create zone page.
xCommand ZoneAdd
•
To edit an existing traversal client zone:
•
VCS configuration > Zones.
You are taken to the Zones page.
Click on the name of the zone you want to configure.
You are taken to the Edit zone page.
xConfiguration Zones Zone [1..1000]
•
xConfiguration Zones Zone [1..1000] Traversal Client
•
For details on the configuration options available for traversal client zones, see the
traversal client zones section.
You can create more than one traversal client zone if you want to connect to multiple
traversal servers.
Overview and System
Introduction
status configuration
D14049.08
November 2010
Adding and configuring a traversal client zone
Configuring
Cisco VCS Zones and Clustering and
configuration neighbors peers
Call Bandwidth
processing control
135
CISCO TELEPRESENCE VIDEO COMMUNICATION SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices