Cisco TelePresence Administrator's Manual page 285

Grey Headline (continued)
Warnings
Warning message
Configuration warning: expected default link between the Traversal Subzone and the Default Zone is missing
Configuration warning: H.323 and SIP modes are set to Off; one or both of them should be enabled
Configuration conflict: H323-SIP Protocol Interworking mode is set to "Registered only" but the H323-SIP Interworking Gateway option key has
been deleted
Configuration warning: IP protocol is set to both IPv4 and IPv6, but the VCS does not have an IPv4 gateway defined
Configuration warning: IP protocol is set to both IPv4 and IPv6, but the VCS does not have an IPv6 gateway defined
Configuration warning: IP protocol is set to both IPv4 and IPv6, but the VCS does not have any IPv4 addresses defined
Configuration warning: IP protocol is set to both IPv4 and IPv6, but the VCS does not have any IPv6 addresses defined
CRL checking required: your login account LDAP server configuration is recommended to have certificate revocation list (CRL) checking set to "All"
when in advanced account security mode
Encryption required: your login account LDAP server configuration is recommended to have encryption set to "TLS" when in advanced account
security mode
HTTPS client certificate checking: client certificate checking mode has changed, however a restart is required for this to take effect
HTTPS client certificate validation: you are recommended to enable client side certificate validation for HTTPS connections when in advanced
account security mode
Invalid clustering configuration: H.323 mode must be turned On - clustering uses H.323 communications between peers
LDAP Configuration required: a valid Server Address, Server Port, BindDN and BaseDN are required if remote login authentication is used for
administrator or FindMe users
NTP server problem: the VCS is unable to determine the correct time and date
Port conflict: one or more ports have been configured for use by more than one service
Restart required: Ethernet configuration has been changed, however a restart is required for this to take effect
Restart required: HTTP service has been changed, however a restart is required for this to take effect
Restart required: HTTPS service has been changed, however a restart is required for this to take effect
Restart required: IP configuration has been changed, however a restart is required for this to take effect
Restart required: port configuration has been changed, however a restart is required for this to take effect
Restart required: QoS settings have been changed, however a restart is required for this to take effect
Restart required: SNMP service has been changed, however a restart is required for this to take effect
Restart required: SSH service has been changed, however a restart is required for this to take effect
Overview and System
Introduction
status configuration
D14049.08
November 2010
Warnings list
Cisco VCS Zones and Clustering and
configuration neighbors peers
Call Bandwidth
processing control
285
CISCO TELEPRESENCE VIDEO COMMUNICATION SERVER
Resolution
Configure default links
Configure H.323 and/or SIP modes
Reconfigure Interworking mode or reinstall the
key
Configure IP settings
Configure IP settings
Configure IP settings
Configure IP settings
Configure login account LDAP server
Configure login account LDAP server
Restart the VCS
Configure HTTPS client certificate validation
Configure H.323 mode
Configure LDAP parameters
Check the time configuration
Review the port configuration
Restart the VCS
Restart the VCS
Restart the VCS
Restart the VCS
Restart the VCS
Restart the VCS
Restart the VCS
Restart the VCS
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
option
Appendices