Cisco TelePresence Administrator's Manual page 36

Grey Headline (continued)
Status
Event
Message Rejected
Message Sent
Message Sent
Message Sent
Operator Call Disconnect
Outbound TLS Negotiation Error The VCS is unable to communicate with another system over TLS. Refer to the event parameters for more information.
Policy Change
POST request failed
Provisioning
Reboot Requested
Registration Accepted
Registration Refresh Accepted
Registration Refresh Rejected
Registration Refresh Requested A request to refresh or keep a registration alive has been received.
Registration Rejected
Registration Removed
Registration Requested
Relay Allocated
Relay Deleted
Overview and System
Introduction
status configuration
D14049.08
November 2010
Description
This could be for one of two reasons:
•
The VCS Authentication mode is set to On, and an endpoint has unsuccessfully attempted to send a message (such as a registration request) to
the VCS. This could be either because the endpoint has not supplied any authentication credentials, or because its credentials do not match those
expected by the VCS.
•
Clustering is enabled but bandwidth across the cluster has not been configured identically, and the VCS has received a message relating to an
unknown peer, link, pipe, subzone or zone.
An outgoing RAS message has been sent.
An outgoing RAS NSM Keepalive, H.225, H.245 or a RAS message between peers has been sent.
(SIP) An outgoing message has been sent.
An administrator has disconnected a call.
A policy file has been updated.
A HTTP POST request was submitted from an unauthorized session.
Diagnostic messages from the provisioning server. The Detail event parameter provides additional information.
A system reboot has been requested. Refer to the Reason event parameter for specific information.
A registration request has been accepted.
A request to refresh or keep a registration alive has been accepted.
A request to refresh a registration has been rejected.
A registration request has been rejected. The Reason and Detail event parameters provide more information about the nature of the rejection.
A registration has been removed by the VCS. The Reason event parameter specifies the reason why the registration was removed. This is one of:
•
Authentication change
•
Conflicting zones
•
Operator forced removal
•
Operator forced removal (all registrations removed)
•
Registration superseded.
A registration has been requested.
A TURN server relay has been allocated.
A TURN server relay has been deleted.
Cisco VCS Zones and
configuration neighbors
Event Log
Clustering and Call Bandwidth
peers processing control
36
CISCO TELEPRESENCE VIDEO COMMUNICATION SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Level
1
2
3
4
1
1
1
1
1
1
1
3
1
3
1
1
1
2
2
Appendices