Cisco TelePresence Administrator's Manual page 244

Grey Headline (continued)
Command reference - xConfiguration
Zones Zone [1..1000] TraversalClient RetryInterval: <1..65534>
Specifies the interval (in seconds) with which a failed attempt to establish a connection to the traversal server should be retried.
Default: 120
Example: xConfiguration Zones Zone 4 TraversalClient RetryInterval: 120
Zones Zone [1..1000] TraversalClient SIP Poison Mode: <On/Off>
Determines whether SIP requests sent out to this zone will be "poisoned" such that if they are received by the local VCS again they will be rejected.
On: SIP requests sent out via this zone that are received again by this VCS will be rejected.
Off: SIP requests sent out via this zone that are received by this VCS again will be processed as normal.
Default: Off
Example: xConfiguration Zones Zone 4 TraversalClient SIP Poison Mode: Off
Zones Zone [1..1000] TraversalClient SIP Port: <1024..65534>
Specifies the port on the traversal server to be used for SIP calls from this VCS. If your traversal server is a VCS Expressway, this must be the port number that has been configured in the
traversal server zone for this VCS.
Example: xConfiguration Zones Zone 4 TraversalClient SIP Port: 5061
Zones Zone [1..1000] TraversalClient SIP TLS Verify Mode: <On/Off>
Controls X.509 certificate checking and mutual authentication between this VCS and the traversal server. When enabled, the server's FQDN or IP address, as specified in the Peer address
field, must be contained within the server's X.509 certificate (in either the Subject Common Name or the Subject Alternative Name attributes).
Default: Off
Example: xConfiguration Zones Zone 4 TraversalClient SIP TLS Verify Mode: On
Zones Zone [1..1000] TraversalClient SIP Transport: <TCP/TLS>
Determines which transport type will be used for SIP calls to and from the traversal server.
Default: TLS
Example: xConfiguration Zones Zone 4 TraversalClient SIP Transport: TLS
Zones Zone [1..1000] TraversalServer Authentication UserName: <S: 1, 128>
The name used by the traversal client when authenticating with the traversal server. If the traversal client is a VCS, this must be the VCS's authentication user name. If the traversal client is
a gatekeeper, this must be the gatekeeper's System Name. For other types of traversal clients, refer to the VCS Admin Guide for further information.
Example: xConfiguration Zones Zone 5 TraversalServer Authentication UserName: "User123"
Zones Zone [1..1000] TraversalServer H323 H46019 Demultiplexing Mode: <On/Off>
Determines whether the VCS will operate in demultiplexing mode for calls from the traversal client.
On: allows use of the same two ports for all calls.
Off: each call will use a separate pair of ports for media.
Default: Off
Example: xConfiguration Zones Zone 5 TraversalServer H323 H46019 Demultiplexing Mode: Off
Overview and System
Introduction
status configuration
D14049.08
November 2010
Cisco VCS Zones and Clustering and
configuration neighbors peers
Call Bandwidth
processing control
244
CISCO TELEPRESENCE VIDEO COMMUNICATION SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices