Cisco TelePresence Administrator's Manual page 209

Grey Headline (continued)
Command reference - xConfiguration
Error Reports Mode: <On/Off>
Determines whether the VCS will automatically send details of application failures to a specified web service.
Default: Off
Example: xConfiguration Error Reports Mode: Off
Error Reports URL: <S: 0, 128>
The URL of the web service to which error reports are sent.
Default: http://vcser.tandberg.com/submitapplicationerror/
Example: xConfiguration Error Reports URL: "http://vcser.tandberg.com/submitapplicationerror/"
Ethernet [1..2] IP V4 Address: <S: 7..15>
Specifies the IPv4 address of the specified LAN port. Note: you must restart the system for any changes to take effect.
Example: xConfiguration Ethernet 1 IP V4 Address: "192.168.10.10"
Ethernet [1..2] IP V4 StaticNAT Address: <S:7..15>
If the VCS is operating in static NAT mode, this specifies the external public IPv4 address of that static NAT. Note: you must restart the system for any changes to take effect.
Example: xConfiguration Ethernet 1 IP V4 StaticNAT Address: "64.22.64.85"
Ethernet [1..2] IP V4 StaticNAT Mode: <On/Off>
Specifies whether the VCS is located behind a static NAT. Note: You must restart the system for any changes to take effect.
Default: Off
Example: xConfiguration Ethernet 1 IP V4 StaticNAT Mode: On
Ethernet [1..2] IP V4 SubnetMask: <S: 7..15>
Specifies the IPv4 subnet mask of the specified LAN port. Note: you must restart the system for any changes to take effect.
Example: xConfiguration Ethernet 1 IP V4 SubnetMask: "255.255.255.0"
Ethernet [1..2] IP V6 Address: <S: 0, 39>
Specifies the IPv6 address of the specified LAN port. Note: you must restart the system for any changes to take effect
Example: xConfiguration Ethernet 1 IP V6 Address: "2001:db8::1428:57ab"
Ethernet [1..2] Speed: <Auto/10half/10full/100half/100full/1000full
Sets the speed of the Ethernet link from the specified LAN port. Use Auto to automatically configure the speed. Note: you must restart the system for any changes to take effect.
Default: Auto
Example: xConfiguration Ethernet 1 Speed: Auto
ExternalManager Address: <S: 0, 128>
Sets the IP address or Fully Qualified Domain Name (FQDN) of the external manager.
Example: xConfiguration ExternalManager Address: "192.168.0.0"
Overview and System
Introduction
status configuration
D14049.08
November 2010
Cisco VCS Zones and Clustering and
configuration neighbors peers
Call Bandwidth
processing control
209
CISCO TELEPRESENCE VIDEO COMMUNICATION SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices