Cisco TelePresence Administrator's Manual page 229

Grey Headline (continued)
Command reference - xConfiguration
Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call to or from an endpoint in the Default Subzone (applies only if the mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Limit: 1920
Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in the Default Subzone.
NoBandwidth: no bandwidth available. No calls can be made to or from the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Mode: Limited
Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within the Default Subzone (applies only if the mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Limit: 1920
Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within the Default Subzone.
NoBandwidth: no bandwidth available. No calls can be made within the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Mode: Limited
Zones LocalZone DefaultSubZone Bandwidth Total Limit: <1..100000000>
Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth Total Limit: 500000
Zones LocalZone DefaultSubZone Bandwidth Total Mode: <Limited/Unlimited/NoBandwidth>
Determines whether the Default Subzone has a limit on the total bandwidth being used by its endpoints at any one time.
NoBandwidth: no bandwidth available. No calls can be made to, from, or within the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth Total Mode: Limited
Zones LocalZone DefaultSubZone Registrations: <Allow/Deny>
Controls whether registrations assigned to the Default Subzone are accepted.
Default: Allow
Example: xConfiguration Zones LocalZone DefaultSubZone Registrations: Allow
Overview and System
Introduction
status configuration
D14049.08
November 2010
Cisco VCS Zones and Clustering and
configuration neighbors peers
Call Bandwidth
processing control
229
CISCO TELEPRESENCE VIDEO COMMUNICATION SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices