Cisco TelePresence Administrator's Manual page 243

Grey Headline (continued)
Command reference - xConfiguration
Zones Zone [1..1000] Neighbor ZoneProfile: <Default/Custom/MicrosoftOCS2007/CiscoUnifiedCommunicationsManager/NortelCS1000/AdvancedMediaGateway>
Determines how the zone's advanced settings are configured.
Default: uses the factory defaults.
Custom: allows you to configure each setting individually.
Preconfigured profiles: alternatively, choose one of the preconfigured profiles to automatically use the appropriate settings required for connections to that type of system.
Default: Default
Example: Zones Zone 3 Neighbor ZoneProfile: Default
Zones Zone [1..1000] SIP Mode: <On/Off>
Determines whether SIP calls will be allowed to and from this zone.
Default: On
Example: xConfiguration Zones Zone 3 SIP Mode: On
Zones Zone [1..1000] TraversalClient Authentication Password: <S: 0..215>
The password used by the VCS when connecting to the traversal server. The maximum plaintext length is 128 characters, which is then encrypted.
Example: xConfiguration Zones Zone 1 TraversalClient Authentication Password: "password123"
Zones Zone [1..1000] TraversalClient Authentication UserName: <S: 0..128>
The user name used by the VCS when connecting to the traversal server.
Example: xConfiguration Zones Zone 1 TraversalClient Authentication UserName: "clientname"
Zones Zone [1..1000] TraversalClient H323 Port: <1024..65534>
Specifies the port on the traversal server to be used for H.323 firewall traversal calls from this VCS. If the traversal server is a VCS Expressway, this must be the port number that has been
configured on the VCS Expressway's traversal server zone associated with this VCS.
Example: xConfiguration Zones Zone 4 TraversalClient H323 Port: 2777
Zones Zone [1..1000] TraversalClient H323 Protocol: <Assent/H46018>
Determines which of the two firewall traversal protocols will be used for calls to and from the traversal server.
Note: the same protocol must be set on the server for calls to and from this traversal client.
Default: Assent
Example: xConfiguration Zones Zone 4 TraversalClient H323 Protocol: Assent
Zones Zone [1..1000] TraversalClient Peer [1..6] Address: <S:0..128>
Specifies the IP address or Fully Qualified Domain Name (FQDN) of the traversal server. If the traversal server is a VCS Expressway cluster, this will be one of the peers in that cluster.
Example: xConfiguration Zones Zone 4 TraversalClient Peer 1 Address: "10.192.168.1"
Zones Zone [1..1000] TraversalClient Registrations: <Allow/Deny>
Controls whether proxied SIP registrations routed through this zone are accepted.
Default: Allow
Example: xConfiguration Zones Zone 4 TraversalClient Registrations: Allow
Overview and System
Introduction
status configuration
D14049.08
November 2010
Cisco VCS Zones and Clustering and
configuration neighbors peers
Call Bandwidth
processing control
243
CISCO TELEPRESENCE VIDEO COMMUNICATION SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices