Cisco TelePresence Administrator's Manual page 238

Grey Headline (continued)
Command reference - xConfiguration
Zones Zone [1..1000] DNS SIP TLS Verify Mode: <On/Off>
Controls X.509 certificate checking between this VCS and the destination system server returned by the DNS lookup. When enabled, the domain name submitted to the DNS lookup must be
contained within the server's X.509 certificate (in either the Subject Common Name or the Subject Alternative Name attributes).
Default: Off
Example: xConfiguration Zones Zone 1 DNS SIP TLS Verify Mode: On
Zones Zone [1..1000] DNS SIP UDP BFCP Filter Mode: <On/Off>
Determines whether INVITE requests sent to this zone filter out UDP/BFCP. This option may be required to enable interoperability with SIP devices that do not support the UDP/BFCP protocol.
On: any media line referring to the UDP/BFCP protocol is replaced with TCP/BFCP and disabled.
Off: INVITE requests are not modified.
Default: Off
Example: xConfiguration Zones Zone 1 DNS SIP UDP BFCP Filter Mode: Off
Zones Zone [1..1000] DNS ZoneProfile: <Default/Custom/MicrosoftOCS2007/CiscoUnifiedCommunicationsManager/NortelCS1000/AdvancedMediaGateway>
Determines how the zone's advanced settings are configured.
Default: uses the factory defaults.
Custom: allows you to configure each setting individually.
Preconfigured profiles: alternatively, choose one of the preconfigured profiles to automatically use the appropriate settings required for connections to that type of system.
Default: Default
Example: xConfiguration Zones Zone 1 DNS ZoneProfile: Default
Zones Zone [1..1000] ENUM DNSSuffix: <S: 0, 128>
Specifies the DNS zone to be appended to the transformed E.164 number to create an ENUM host name which this zone is then queried for.
Example: xConfiguration Zones Zone 2 ENUM DNSSuffix: "e164.arpa"
Zones Zone [1..1000] H323 Mode: <On/Off>
Determines whether H.323 calls will be allowed to and from this zone.
Default: On
Example: xConfiguration Zones Zone 2 H323 Mode: On
Zones Zone [1..1000] HopCount: <1..255>
Specifies the hop count to be used when sending an alias search request to this zone. Note: if the search request was received from another zone and already has a hop count assigned, the
lower of the two values will be used.
Default: 15
Example: xConfiguration Zones Zone 2 HopCount: 15
Zones Zone [1..1000] Name: <S: 1, 50>
Assigns a name to this zone.
Example: xConfiguration Zones Zone 3 Name: "UK Sales Office"
Overview and System
Introduction
status configuration
D14049.08
November 2010
Cisco VCS Zones and Clustering and
configuration neighbors peers
Call Bandwidth
processing control
238
CISCO TELEPRESENCE VIDEO COMMUNICATION SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices