Cisco TelePresence Administrator's Manual page 233

Grey Headline (continued)
Command reference - xConfiguration
Zones LocalZone Traversal H323 TCPProbe RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a TCP probe to the VCS.
Default: 5
Example: xConfiguration Zones LocalZone Traversal H323 TCPProbe RetryCount: 5
Zones LocalZone Traversal H323 TCPProbe RetryInterval: <1..65534>
Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will send a TCP probe to the VCS.
Default: 2
Example: xConfiguration Zones LocalZone Traversal H323 TCPProbe RetryInterval: 2
Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered directly with the VCS will send a UDP probe to the VCS once a call is established, in order to keep the
firewall's NAT bindings open.
Default: 20
Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: 20
Zones LocalZone Traversal H323 UDPProbe RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a UDP probe to the VCS.
Default: 5
Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe RetryCount: 5
Zones LocalZone Traversal H323 UDPProbe RetryInterval: <1..65534>
Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will send a UDP probe to the VCS.
Default: 2
Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe RetryInterval: 2
Zones LocalZone TraversalSubZone Bandwidth PerCall Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) applied to any one traversal call being handled by the VCS (applies only if the mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth PerCall Limit: 1920
Zones LocalZone TraversalSubZone Bandwidth PerCall Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth of any one traversal call being handled by the VCS.
NoBandwidth: no bandwidth available. No traversal calls can be made.
Default: Unlimited
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth PerCall Mode: Limited
Overview and System
Introduction
status configuration
D14049.08
November 2010
Cisco VCS Zones and Clustering and
configuration neighbors peers
Call Bandwidth
processing control
233
CISCO TELEPRESENCE VIDEO COMMUNICATION SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices