Figure 3-18: Sbus Receiver Linking Cable - Honeywell ADEMCO MX8000 Installation And Operation Manual

MX8000 Installation and Operation Guide
3.14.2.1 Master Printer/Slave Printer Linking Programming
To perform MasterPrn/SlavePrn Linking Programming, follow these steps:
1. Verify that all SBUS connections have been made as described in Section 3.14.1 and shown in Figure 3–
17.
2. Program the Master (MstrPrn) Receiver as follows:
a. Power up the Master Receiver and allow the Line Cards to be initialized.
b. From the "Installer/Program Menu/General Options" display, select "1 Operation Mode" and
configure for "Automatic."
c. From the "3 Communications" display, select "1 Port Functions" and configure COM1 for
"Automation" and parallel port for "Auto Bkp Prn."
Note: If a serial printer is being used as a automation backup printer, configure COM2 as the "Auto
Bkp Prn" instead of the parallel port.
d. From "4 System Options" select "MstrPrn" and set appropriate "Rcvr ID."
e. From "6 Slave List" enter a unique Slave number for each slave receiver.
f. Exit the programming mode and cycle power on the Master Receiver for the new settings to take
effect.
3. Program the Slave (SlvPrn) Receiver as follows:
a. Power up the Slave Receiver and allow the Line Cards to be initialized.
b. From the "Installer/Program Menu/General Options" display, select "1 Operation Mode" and
configure for "Automatic."
c. From the "3 Communications" display, select "1 Port Functions" and configure COM1 for
"Automation."
d. From "4 System Options" select verify "SlvPrn" setting and set appropriate "Rcvr ID." matching the
number programmed in the Master Receiver.
e. Exit the programming mode.
f. Repeat a. through e. on the second Slave Receiver, if being used.
3.14.2.2 Master Automation/Slave Automation Linking Programming
To perform MasterAuto/SlaveAuto Linking Programming, follow these steps:
1. Program the Master (MstrAuto) Receiver as follows:
a. Power up the Master Receiver and allow the Line Cards to be initialized.
b. From the "Installer/Program Menu/General Options" display, select "1 Operation Mode" and
configure for "Automatic."
3–14
6 5 4 3 2 1
LOCK/UNLOCK
TAB UP
Figure 3–18: SBUS Receiver Linking Cable
RJ-11
CONNECTORS
LOCK/UNLOCK
TAB DOWN
BLACK
RED
GREEN
YELLOW
1 2 3 4 5 6
00-MX8000-005-V0