Honeywell ADEMCO MX8000 Installation And Operation Manual page 125

5. Press the or
11 for description.
ENTER
6. Press .
MENU
7. Press the or
8. Press the or
this device back to default.
When all the device numbers (of the devices you wish to program to factory defaults) are chosen.
Warning: The following step cannot be undone.
9. Press .
5.5.5.2 Copy the Programming of an Existing Device to Another
1. Enter Program Mode (see section 5.1).
2
2. Press for Line Device menu.
1
3. Press (MX8000–LC3),
3
4. Press for copy Line Device menu.
5. Press the or
for description.
ENTER
6. Press .
MENU
7. Press the or
ENTER
8. Press .
MENU
9. Press the or
10. Press the or
this line device with the programming of the line device chosen as the source.
11. Repeat steps 8 & 9 until all the line card numbers (of the Lines you wish to program to factory defaults)
are chosen.
Warning: The following step cannot be undone.
12. Press .
button until the equal sign is adjacent to the Use Defaults option. See Table 5–
button until the equal sign highlights the desired Device number.
ENTER
button to toggle between Y (yes) or N (no). Yes means you wish to program
MENU
2
(MX8000–LRR), or
button until the equal sign is adjacent the Copy Existing option. See Table 5–11
button until the equal sign highlights the desired Source Device number.
button until the equal sign highlights the desired Target Device number.
ENTER
button to toggle between Y (yes) and N (no). Yes means you wish to program
MENU
3
(MX8000–LC1) to select your line card type.
Section 5 – Programming
5–69