Table of Contents
Advertisement
How to Set Caller ID
Caller ID information is only sent if the incoming call has no data contained in it.
Notes: Caller ID to Automation – When enabled, Caller ID information is output to the automation system
only in the event that no alarm data is received from a security system control panel.
Caller ID to Printer Ports – When enabled, Caller ID information is output to the printer port(s) for
every call received at the time that the Caller ID information is available from the Public Switched
Telephone Network (normally between the first and second ring.) This option should only be used
when connected to a parallel or serial printer or equivalent.
1. Follow the procedures in Section 5.5.2.
5
2. Press
for Miscellaneous Line Options menu (see Figure 5–18).
The display Flashes on the Echo Spr= field.
3. Press
until the display flashes on the Call ID field.
4. Press the
or
5. When the setting is flashing press
To Change the Billing Delay Setting:
If billing delay is enabled (Y), a delay of two seconds will be inserted at the beginning of each incoming call.
1. Follow the procedures in Section 5.5.2.
5
2. Press
for Miscellaneous Line Options menu.
3. Press
until the display flashes on the BillDly field.
4. Press the
or
5. When the desired setting is flashing press
To Change the Hunt Group:
Note: If a Hunt Group number is assigned to a line that has a virtual line number assigned, the Hunt
Group Number will take precedence and the virtual line and receiver numbers will be ignored.
1. Follow the procedures in Section 5.5.2.
5
2. Press
for Miscellaneous Line Options menu.
3. Press
until the display flashes on the HntGrp field.
4. Enter the desired value from the keypad or press the
number.
Notes:
•
If using the ADEMCO 685 or ADEMCO 685 CAPS Automation Protocol, valid entries are 00 through
08.
•
If using the CP-220 Automation Protocol, valid entries are 00 through 09 or 65 (A) through 70 (F).
Keypad entries for A through F are provided in Table 5–10 on page 5–23.
button to change the caller ID option from Y (Yes) to N (No) or vice versa.
ENTER
.
MENU
button to toggle the billing delay between "Yes" or "No".
ENTER
MENU
.
or
button to change the hunt group
Section 5 – Programming
5–47
Advertisement
Table of Contents
Troubleshooting
