Table of Contents
Advertisement
5.5.4.5
Misc. Line Opt.
Some phone lines may use echo suppression, a billing
delay feature, a hunt group or you may need to set
various ring options. These miscellaneous phone options
can be set through this programming menu.
To Change the Echo Suppress Setting:
If echo suppression is enabled (Y) a 2025Hz signal will be output for two seconds to disable echo suppression
equipment. This option should be used only for panels that require a 2225Hz handshake.
1. Follow the procedures in Section 5.5.4.
5
2. Press
for Miscellaneous Line Options menu (see Figure 5–28).
The display Flashes on the Echo Spr= field.
3. Press the
or
4. When the setting is flashing press
How to Set Caller ID
Caller ID information is only sent if the incoming call has no data contained in it.
Notes: Caller ID to Automation – When enabled, Caller ID information is output to the automation system
only in the event that no alarm data is received from a security system control panel.
Caller ID to Printer Ports – When enabled, Caller ID information is output to the printer port(s) for
every call received at the time that the Caller ID information is available from the Public Switched
Telephone Network (normally between the first and second ring.) This option should only be used
when connected to a parallel or serial printer or equivalent.
1. Follow the procedures in Section 5.5.4.
5
2. Press
for Miscellaneous Line Options menu (see Figure 5–28).
The display Flashes on the Echo Spr= field.
3. Press
until the display flashes on the Call ID field.
4. Press the
or
5. When the setting is flashing press
To Change the Billing Delay Setting:
If billing delay is enabled (Y), a delay of two seconds will be inserted at the beginning of each incoming call.
1. Follow the procedures in Section 5.5.4.
5
2. Press
for Miscellaneous Line Options menu.
button to change the echo suppress option from Y (Yes) to N (No) or vice versa.
ENTER
.
MENU
button to change the caller ID option from Y (Yes) to N (No) or vice versa.
ENTER
.
MENU
<Edit Line :01>
5 Misc. Line Opt.
< Exit Menu
Echo Spr=N Call ID=Y
BillDly=N HntGrp=00
HngUp=120
<Echo Suppress<=Exit>
Figure 5–28: MX8000–LC1 Miscellaneous Phone
Line Options
Section 5 – Programming
5–65
Advertisement
Table of Contents
Troubleshooting
