Honeywell ADEMCO MX8000 Installation And Operation Manual page 114

MX8000 Installation and Operation Guide
4. Enter the desired value from the keypad or press the
5. When the desired handshake delay time is flashing press
To Change the Handshake Duration Time:
The handshake duration is the length of time that the receiver will send a handshake tone. See Table 5–11
for valid entries.
1. Follow the procedures in Section 5.5.4.
1
2. Press for handshake sequence menu.
3. Press until the display flashes on the Dur field.
4. Enter the desired value from the keypad or press the
duration time.
5. When the desired handshake duration time is flashing press
To Change the Maximum Handshake Wait Time:
The wait time is the amount of time the receiver will wait for data from the reporting panel before
outputting the next handshake sequence. See Table 5–11 for valid entries.
1. Follow the procedures in Section 5.5.4.
1
2. Press for handshake sequence menu.
3. Press until the display flashes on the Wait field.
4. Enter the desired value from the keypad or press the
5. When the desired wait time is flashing press
To Change the Acknowledgment Tone Duration Time:
The acknowledgment tone duration time is the amount of time the receiver will send an acknowledgment
tone to the reporting panel. See Table 5–11 for valid entries.
1. Follow the procedures in Section 5.5.4.
1
2. Press for handshake sequence menu.
3. Press until the display flashes on the AckDur field.
4. Enter the desired value from the keypad or press the
ment tone duration time.
5–58
or button to change the delay time.
ENTER
or
MENU
or button to change the handshake
ENTER
MENU
or button to change the wait time.
ENTER
or .
MENU
or button to change the acknowledg-
.
or .