Communications; Table 5-5: Communications Options And Description; Figure 5-6: Communications Options Menu - Honeywell ADEMCO MX8000 Installation And Operation Manual

MX8000 Installation and Operation Guide
4. Press until the display flashes on the bright field.
5. Press the or
ENTER
6. Press .
MENU
5.4.3

Communications

In the communication option the installer can configure the
communication ports, automation configuration, annunciator
configurations, and the auxiliary relay configurations.
Table 5–5 lists the available choices and gives a description of
those choices.
Communications
Choices
Menu
Com1
Com2
Communications
Port Functions
Par
5–12
button until the display flashes on the desired setting.
Table 5–5: Communications Options and Description
Options
Unused
Automation
Printer
Unused
Diagnostics
Printer
[Auto Bkp]
[Auto Bkp Prn]
[Printer Bkp]
Unused
Diagnostics
Printer
[Auto Bkp Prn]
<Communications>
1=Port Functions
2 Com Port1: Unused
3 Com Port2: Unused
<Communications>
4=Par Port: Unused
5 Automation Cfg
6 Annunciator Cfg
<Communications>
7=Aux Relay Cfg
< Exit Menu
Figure 5–6: Communications Options Menu
Default
✔
Rules for Port Functions:
1. Functions in Brackets [ ] will not appear unless
"Automation" is selected for Com1 function.
✔
2. Functions in { } will not appear unless "Printer" is
selected in Com1 or Par.
3. A function may be selected only once in the 3 ports
(only one printer, only one Diag, and so on).
4. All ports may be configured "Unused".
5. Only Com Port 1 can be set as the primary
automation port.
Would output raw Hex-ASCII code.
English output to a printer.
Would act as a backup automation port if a fault
occurred with the primary automation port.
Would act as a backup print output port if a fault
occurred with the automation port.
Would act as a backup printer port if a fault occurred
with the primary printer port.
✔
Would output raw Hex-ASCII
code.
English output to a printer.
Would act as a backup print
output port if a fault occurred
with the automation port.
¯
­
¯
­
Comments
Note: The receiver
printer port is enabled
at the factory. You will
receive a trouble
condition when a
printer is not attached.