Mx8000 Supported Sia Digital I-Iii Levels; How To Use This Manual; Table 1-3: Mx8000 And Sia Levels I-Iii Comparison - Honeywell ADEMCO MX8000 Installation And Operation Manual

1.4

MX8000 Supported SIA Digital I-III Levels

Table 1–3 compares the MX8000 receiver to SIA Digital Compatibility Levels I, II, and III and indicates
which of them we comply with.
1.5

How to Use this Manual

This manual contains information on how to install, operate and program the MX8000 receiver. We strongly
suggest that the manual be reviewed in its entirety to become familiar with procedures and parameters of
the product. Once you are familiar with the product, the manual can be used as a reference document.
This manual uses the following conventions:
• A small graphic of each touchpad button is used to represent which touchpad key is to be pressed for a
given operation. For example, an up-arrow would be shown as:
•
VFD display This represents messages that appear on the VFD (display).
•
2225Hz This typeface represents an editable field that appears on the VFD (display).
• Pages of the manual are numbered by section. For example, a page numbered as "5-1" is Page 1 of Section
5.
• When this manual refers to default settings, it means programmable options set at the factory. Any
programming after the receiver is powered up will change these setting.
Table 1–3: MX8000 and SIA Levels I-III comparison
8000 Function/Capability
✔
Support Tonal Acknowledgments
✔
Support N blocks with Zone Numbers Only
✔
Support single Account Block per Call
✔
Support O Blocks
✔
Support X Blocks
✔
Support 300 Baud (Fast)
Support Configuration Block
Support Data Acknowledgments
✔
Support Modifier codes id , da and ti .
✔
Support Multiple Account Blocks per Call
✔
Support E Blocks
✔
Support Data Codes with Units Numbers
Support RECEIVER call out and Access Passcode
Support Reverse Channel C Blocks
Support Reverse Channel P Blocks
Support Reverse Channel A Blocks
Support Dynamic block and Group Sizes
✔
Support Listen-in
✔
Support A Blocks to RECEIVER
Support V-Channel communication
Section 1 – System Overview
Transmitter Receiver
required required
required required
required required
(optional) required
(optional) required
(optional) required
required required
required required
(optional) required
(optional) required
(optional) required
(optional) required
required required
required required
required (optional)
(optional) required
(optional) required
(optional) required
(optional) required
(optional) (optional)
1–3