Figure 5-7: Initialization String Display - Honeywell ADEMCO MX8000 Installation And Operation Manual

MX8000 Installation and Operation Guide
2
4. Press to set Com Port1 parameters.
5. Press the or
ENTER
6. Press .
MENU
Note: See "How to Edit Init String (Com 1, Com 2, and Parallel Port)" in Section 5.4.3.4.
7. Repeat steps 5 through 6 until all parameters are set.
8. Press to exit menu.
5.4.3.3 How to Set Com Port 2 Parameters
Set the baud rate, the number of data bits, number of stop bits, the parity, and the flow control (see Table 5–
5 for choice details).
1. Enter program mode. (See Section 5.1.)
1
2. Press for general options.
3
3. Press for communications.
3
4. Press to set Com Port 2 parameters.
5. Press the or
ENTER
6. Press .
MENU
Note: See "How to Edit Init String (Com 1, Com 2, and Parallel Port)" in Section 5.4.3.4.
7. Repeat steps 5 through 6 until all parameters are set.
8. Press to exit menu.
5.4.3.4 How to Edit Init String (Com 1, Com 2, and Parallel Port)
An initialization string can be used to customize the output to the device connected to a port on the receiver.
For example, you can skip over perforations, set proportional spacing, or condense the print output to a
printer. The display format for the init string is shown in Figure 5–7 and Table 5–6 lists the characters that
can be entered into the string.
Note: Refer to the user manual of the device connected to the receiver for special command sequences.
Follow these steps to insert an initialization string:
5–16
button until the display flashes on the desired port setting.
button until the display flashes on the desired port setting.
<Edit Init String>
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _
First 20
Digit String
Clear String=N
<Edit Init String>
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Second 20
Clear String=N
Digit String
Figure 5–7: Initialization String Display
ENTER
MENU
N = do not clear init string
Y = Clear init string
Press to toggle Y or N
E c = ESC or Escape