Honeywell ADEMCO MX8000 Installation And Operation Manual page 97

5.5.2.2 Pulse Format
Select how this line card will handle pulse formats that are outside the standards for pulse format protocol.
To Select Which Format a 5-digit Pulse Format will be received as:
1. Follow the procedures in Section 5.5.2.
2
2. Press for pulse format menu.
3. When the display flashes on the 5-digit Fmt field.
4. Select the format by pressing the
5. When the desired wait time is flashing press
To Select Which Format a 6-digit Pulse Format will be received as:
1. Follow the procedures in Section 5.5.2.
2
2. Press for pulse format menu.
3. Press until the display flashes on the 6-digit Pulse Fmt field.
4. Select the format by pressing the
5. When the desired wait time is flashing press
To Select the Inter-Digit Time:
This option adjusts the time period between data blocks that the receiver will tolerate.
1. Follow the procedures in Section 5.5.2.
2
2. Press for pulse format menu.
3. Press until the display flashes on the Timeout field.
Note: When the Timeout field is set to 0 (recommended), the MX8000 uses an algorithm to determine the
inter-digit time. When set between 1 ms and 2000 ms, the time entered will be used.
4. Enter the desired value from the keypad or press the
5. When the desired wait time is flashing press
Set for 2300 and 1400 formats that require Acknowledgements on Even Rounds:
1. Follow the procedures in Section 5.5.2.
2
2. Press for pulse format menu.
3. Press until the display flashes on the Ack/ Even field.
4. Select the format by pressing the
5. When the desired wait time is flashing press
or button.
ENTER
or .
MENU
or button.
ENTER
or .
MENU
or
ENTER
or .
MENU
or button.
ENTER
or .
MENU
Section 5 – Programming
button.
5–41