Parameter 18: Bs - Honeywell FBII CP-220A Hookup And Installation Instructions

PARAMETER 18:
BS
REMEMBER!
To leave the Programming
Mode at any time, press the
Esc key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
PARAMETER 19:
CR
REMEMBER!
To leave the Programming
Mode at any time, press the
Esc key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
BS 08
Background:
Upon entering PARAMETER 18, [BS 08] will be displayed. This parameter
has been factory programmed with the ASCII control code [08],
representing the BackSpace command. PARAMETER 18 is intended to
remain this way and must not be altered.
NOTE: See PARAMETER 11 (on page 2-79) for information on ASCII
coding and the ASCII Character Set.
Advancing to Next Parameter:
After programming PARAMETER 18, press the N key to advance to
PARAMETER 19 – the next parameter in Category C.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 18]) with its first digit flashing, indicating its request for the
next parameter number. Press either:
• 1 then 9 , or
• then
• the
NOTE: When the
immediately – not its number.
CR 00
Background:
Upon entering PARAMETER 19, [CR 0D] will be displayed. This parameter
has been factory programmed with the ASCII control code [0D],
representing the Carriage Return command. Like PARAMETER 18,
PARAMETER 19 is intended to remain this way and must not be altered.
NOTE: See PARAMETER 11 (on page 2-79) for information on ASCII
coding and the ASCII Character Set.
Advancing to Next Parameter:
The next parameter in Category C is PARAMETER 13. Because it is not
sequential, it cannot be reached with a single press of the
advance to PARAMETER 13, press the N key.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 19]) with its first digit flashing, indicating its request for the
next parameter number.
You can reach PARAMETER 13 by pressing the 1 key and the 3 key.
CP-220A Central Station Receiver
Hook-Up and Installation Manual
MM/DD/YY HH:MM:SS
key and 9 , or
key
is used, the name of the next parameter appears
MM/DD/YY HH:MM:SS
Section 2: Programming the CP-220A Page 2-85
key. To