Table 5-6: Initialization String Characters - Honeywell ADEMCO MX8000 Installation And Operation Manual

0-9
a-z and A-Z
: _ - . , & * # ?
ENTER
1. Press at the flashing <Init Str> field.
MENU
2. Press the or
3. Press , the next character position will flash.
4. Repeat steps 2 and 3 until the desired sequence is complete.
ENTER
5. Press .
MENU
6. Repeat steps 2 through 5 for the second string.
To clear an init string:
1. At the Clear String=N field, press
ENTER
2. Press .
MENU
3. Press to exit menu.
5.4.3.5 How to Set Automation Communication
Through this option the automation communication format and parameters can be set up. (See Table 5–5 for
format choices.)
Note: After the automation format has been defined or changed, the output may not be correct until the
receiver has been reset.
How to Set the Format
Follow these steps to set the automation communication format.
1. Enter program mode. (See Section 5.1.)
1
2. Press for general options.
3
3. Press for communications.
5
4. Press to setup automation configuration.
5. Press the or
ENTER
6. Press .
MENU
7. Press if you wish to exit menu or continue with heartbeat.
Table 5–6: Initialization String Characters
Character
E
C and space bar.
button until the desired character flashes.
until the desired option flashes. See Figure 5–7.
button until the display flashes on the desired port setting.
Description
Numeric characters, which can be entered from the
touchpad or up/down arrows.
Alpha characters entered with the up/down arrows.
Special Characters entered with the up/down arrows.
Section 5 – Programming
5–17