Table of Contents
Advertisement
5.5.4.1
Handshake Sequence
Each line card is intelligent enough to determine
what format is being sent from a reporting panel. You
only need to program the handshake order and
parameters for each line. A line will initiate up to six
different types of handshake tone groups. The order in
which the receiver sends out these handshake signals
can be changed in this program location for each line
card. Table 6–1 in Section 6 lists the proper
handshake to use for the type of communication
format you are using with a panel.
Follow these steps to change the handshake order and
or the parameters associated with the handshake.
To Change the Handshake Sequence Number:
Handshake sequence sets the order in which the receiver will send out handshakes.
1. Follow the procedures in Section 5.5.4.
1
2. Press
for handshake sequence menu.
When display flashes on the Hs# (see Figure 5–23).
3. Press the
or
handshake number.
1 = the first handshake tone sent
handshake tone to be sent and so on.
4. When the desired order number is flashing press
The display will start flashing the format group field.
To Change the Format Group:
1. Follow the procedures in Section 5.5.4.
1
2. Press
for handshake sequence menu.
3. Press
until the display flashes on the Format Group field. See Table 5–11 for valid entries.
4. Press the
or
communication format.
5. When the desired format group is flashing press
To Change the Handshake Delay Time:
This is the duration of time that the receiver will wait before it sends its handshake tone. See Table 5–11 for
valid entries.
1. Follow the procedures in Section 5.5.4.
1
2. Press
for handshake sequence menu.
3. Press
until the display flashes on the Delay field.
button to change the ordered
2 = the second
button to change the format group. See Table 6–1 in Section 6 for your
<Edit Line: 01>
1=Handshake Seq.
2 Pulse Format
3 Line Options
Hs=1
Gr=1400_2300–2
Delay=002
Wait=025 AckDur=080
<Seq # <=Exit>
Figure 5–23: MX8000–LC1 Handshake Sequence
Hs=1
Gr=1400_2300–2
Delay=002
Wait=025 AckDur=080
<Seq # <=Exit>
Figure 5–24: MX8000–LC1 Handshake Order
ENTER
or
.
MENU
ENTER
or
.
MENU
Section 5 – Programming
¯
Dur=010
Menu
Dur=010
Number
5–57
Advertisement
Table of Contents
Troubleshooting
