Mx8000/Cp-220 System Messages; Table 8-25: Mx8000/Cp-220 System Messages; Figure 8-12: Cp-220/Silent Knight Format 6 (Fsk 2) - Honeywell ADEMCO MX8000 Installation And Operation Manual

MX8000 Installation and Operation Guide
FORMAT 6
When the MX8000 receives a Silent Knight Format 6 (FSK 2) transmission, the output protocol to the
computer is as shown in Figure 8–12.
8.7.6

MX8000/CP-220 System Messages

The MX8000 generates messages to the automation computer for system generated troubles/restores and
operator generated troubles/restores while operating using the CP-220 automation protocol. These message
are listed in Table 8–25.
Printer Message
Main Computer Trouble
Bkup Computer Trouble
Main Printer Off Line
Main Printer Paper Out
Bkup Printer Off Line
Bkup Printer Paper Out
AC Trouble
DC Input Low
Battery Low
Main Computer Trouble
Restore
Bkup Computer Restore
Main Printer Restore
Bkup Printer Restore
AC Trouble Restore
DC Input Low Restore
Battery Low Restore
System Power Up
System Warm Boot User
Message Queue Warning
Message Queue Full (See
Important Note below)
Message Queue Warning
Restore
Message Queue Full Restore
Flash Checksum Error
IMPORTANT NOTE: A "Message Queue Full" system message indicates that the MX8000 call event buffer is full and the
MX8000 receiver has gone into a "Stop Answering Mode". This has occurred because either the printer or automation
system has failed and the MX8000 began logging events internally (eventually filling up its internal buffer). No more calls
will be accepted until the MX8000 can free up part of its event buffer to either the printer and/or automation
system (depending upon how the system has been configured).
8–24
RG1234564131T
PROGRAMMABLE TERMINATOR
PREMISE CODE
ACCOUNT NUMBER
GROUP NUMBER
RECEIVER NUMBER
Figure 8–12: CP-220/Silent Knight Format 6 (FSK 2)
Table 8–25: MX8000/CP-220 System Messages
CP-220 Automation
Output
r0RCVA11t
r0RCVA14t
r0RCVA15t
r0RCVA16t
r0RCVA31t
r0RCVA34t
r0RCVA35t
r0RCVA36t
r0RCVB01t
r0RCVB18t
r0RCVB38t
r0RCVB44t
Printer Message
LC Line Fault Event
LC Line Fault Restore Event
No Data Received
0 Length Blk
No ACK
Time Out
Illegal Specifier
Undefined Event
Unsupported Event
Unsupported Fmt
Possible Incomplete Call
Event Unsupported By
Automation
Corrupted Data
Communication Error, Panel
Requested Re-send
Expander Trouble
Slave Expander Trouble
Expander Trouble Restore
Slave Expander Trouble
Restore
User Log In: User
User Log Out: User
CP-220 Automation
Output
rgLINE1xt (x = line #)
rgLINE3xt (x = line #)
rgRCVB16t
rgRCVB26t
rgRCVB5xt (x = line #)
rgRCVB7xt (x = line #)
rOhhhh17t (hhhh =
user #)
rOhhhh27t (hhhh =
user #)