D-Link xStack DGS-3420 Series Reference Manual page 529

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
ports - Specify the list of ports that you would like to clear the ND snoop learned entry.
<portlist> - Enter the list of port used here.
all - Clear all ND snooping learned entries.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear ND snooping entry on ports 1-3:
DGS-3420-28SC:admin# clear address_binding nd_snoop binding_entry ports 1-3
Command: clear address_binding nd_snoop binding_entry ports 1-3
Success.
DGS-3420-28SC:admin#
44-26 config address_binding dhcp_snoop_entry filename
Description
This command is used to configure the autosave state of DHCPv4 Snooping binding entries.
Note: This feature is only supported on devices that support external memory. For example,
SD card.
Format
config address_binding dhcp_snoop_entry filename <path_filename 64> {autosave [enable |
disable]}
Parameters
<path_filename 64> - Enter the pathname, on the device's file system, to autosave the DHCPv4
Snooping binding entries.
autosave - (Optional) Specifies the auto-save state.
enable - Specifies that the auto-save feature will be enabled.
disable - Specifies that the auto-save feature will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the auto-save option:
524