D-Link xStack DGS-3420 Series Reference Manual page 649

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To configure the MLD Proxy's downstream interface:
DGS-3420-28SC:admin#config mld_proxy downstream_if add vlan vlanid 2-7
Command: config mld_proxy downstream_if add vlan vlanid 2-7
Success.
DGS-3420-28SC:admin#
57-4 config mld_proxy upstream_if
Description
This command is used to configure the setting for the MLD proxy's upstream interface. The MLD proxy
plays the host role on the upstream interface. It will send MLD report packets to the router port. The
source IP address determines the source IP address to be encoded in the MLD protocol packet. If the
router port is empty, the upstream will send the MLD protocol packet to all member ports on the
upstream interface.
Format
config mld_proxy upstream_if {vlan [<vlan_name 32> | vlanid <vlanid 1-4094>] | router_ports
[add | delete] <portlist> | source_ip <ipv6addr> | unsolicited_report_interval <sec 0-25>}(1)
Parameters
vlan - Specify the VLAN for the upstream interface.
<vlan_name 32> - Specify a VLAN name between 1 and 32 characters.
vlanid - Specify the VLAN ID for the upstream interface.
<vlanid 1-4094> - Specify the VLAN ID between 1 and 4094.
router_ports - Specify a list of ports that are connected to multicast-enabled routers.
add - Specify to add the router ports.
delete - Specify to delete the router ports.
<portlist> - Specify a range of ports to be configured.
source_ip - Specify the source IPv6 address of the upstream protocol packet. If it is not specified,
zero IP address will be used as the protocol source IP address.
<ipv6addr>> - Specify the IPv6 address.
unsolicited_report_interval - Specify the time between repetitions of the host's initial report of
membership in a group. The default is 10 seconds. If set to 0, only one report packet is sent.
<sec 0-25> - Specify the time between 0 and 25 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
644