D-Link xStack DGS-3420 Series Reference Manual page 749

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Note: The configuration does not take effect until saved.
Format
disable password_recovery
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To disable the password recovery mode:
DGS-3420-28SC:admin# disable password_recovery
Command: disable password_recovery
Success.
DGS-3420-28SC:admin#
66-3 show password_recovery
Description
The command is used to display the password recovery state. The displayed content includes both the
running configuration and the NV-RAM configuration.
When the password recovery state is enabled a user can reboot the switch and enter into the
Password Recovery mode. Otherwise, if the Password Recovery state is disabled a user will not be
able to enter into the special recovery mode.
Note: Only the NV-RAM configuration will take effect when the switch restarts next time, the
running configuration does not take effect until saved. That means the password
recovery is determined by the state stored in the NV-RAM and take effect at the next
time switch start up. The Running Configuration is the current configured state of the
password recovery, it will lost without save, or become the NV-RAM configuration if
save the configurations.
Format
show password_recovery
744