D-Link xStack DGS-3420 Series Reference Manual page 948

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
entry. Therefore, the resource entry consumed by a replication entry is not constant and it will be
determined by the number of (V, G, S) pairs defined by the entry. If the entry (V, G, S) exists in two
replication entries, both will take effect. The traffic will be replicated to the destination defined by both
entries.
Format
config ipmc_vlan_replication_entry source <name 16> [[vlan <vlan_name 32> | vlanid <vlanid
1-4094>] | group [add | delete] mcast_ip <mcast_address_list> {source_ip <ipaddr>}]
Parameters
<name 16> - Specify the name of the IP multicast VLAN replication entry to be configured. This
name can be up to 16 characters long.
vlan - Specify the source VLAN name.
<vlan_name 32> - The VLAN name can be up to 32 characters long.
vlanid - Specify the source VLAN ID.
<vlanid 1-4094> - The VLAN ID must be between 1 and 4094.
group - Specify the multicast IP address list.
add - Specify to add a group.
delete - Specify to delete a group.
mcast_ip - Specify the multicast IP address list.
<mcast_address_list> - Enter the multicast IP address list here.
source_ip - (Optional) Specify the source IP address.
<ipaddr> - Enter the source IP address here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the source VLAN of an IP multicast VLAN replication entry to VLAN v2:
DGS-3420-28SC:admin#config ipmc_vlan_replication_entry source mr1 vlan default
Command: config ipmc_vlan_replication_entry source mr1 vlan default
Success.
DGS-3420-28SC:admin#
21-5 delete ipmc_vlan_replication_entry
Description
This command is used to delete an IP multicast VLAN replication entry.
Format
delete ipmc_vlan_replication_entry <name 16>
943