Show Poe Ports - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
units - (Optional) Specifies the unit list that will be configured.
<unitlist> - Enter the unit list, used for this configuration, here.
all - Specifies that all the units will be used for this configuration.
power_limit - (Optional) Specifies the power budget of the PoE system.
<value 37-760> - Enter the power budger limit value here. This value must be between 37 and
760.
power_disconnect_method - (Optional) Specifies the disconnection method that will be used when
the power budget is running out. When the system attempts to supply power to a new port, if the
power budget is insufficient to do this, the PoE controller will initiate a port disconnection
procedure to prevent overloading the power supply. The controller uses one of the following two
ways to perform the disconnection procedure.
deny_next_port - Specifies the port with the maximum port number will be denied regardless of
its priority. If the disconnect method is set to deny the next port, the power provision will not
utilize the system's maximum power. There is a 19W safety margin. That is, when the system
has only 19W remaining, this power cannot be utilized.
deny_low_priority_port - If there are ports that supplied power, that have a priority lower than
the new port, the port with the lowest priority will be disconnected. This process will stop until
enough power is released for the new port. Note that if the disconnect method is set to deny
low priority port, then the power provision can utilize the system's maximum power.
legacy_pd - (Optional) Specifies the legacy PDs detection status.
enable - Specifies that the legacy PDs detection status will be enabled.
disable - Specifies that the legacy PDs detection status will be disabled and can't detect the
legacy PDs signal.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the PoE system-wise setting:
DGS-3420-28PC:admin#config poe system power_limit 250 power_disconnect_method
deny_low_priority_port
Command: config poe system power_limit 250 power_disconnect_method
deny_low_priority_port
Success.
DGS-3420-28PC:admin#
69-3

show poe ports

Description
This command is used to display the settings and actual values of the PoE port.
761