Create Ipif - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
disable - Specifies that the clear DHCP Option 12 hostname setting will be disabled.
dhcpv6_client_pd - Specifies the DHCPv6 client PD state of the interface.
enable - Specifies to enable the DHCPv6 client PD state of the interface.
prefix_name - Specifies an alias name for the prefix requested from the delegation router. If
disabled, the DHCPv6 client PD name will automatically be cleared.
<string 1-12> - Enter the prefix alias name used here. This name can be up to 12
characters long.
disable - Specifies to disable the DHCPv6 client PD state of the interface.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the System IP interface:
DGS-3420-28SC:admin#config ipif System vlan v1
Command: config ipif System vlan v1
Success.
DGS-3420-28SC:admin#
To configure the DHCPv6 client PD state of the System interface to enabled:
DGS-3420-28SC:admin#config ipif System dhcpv6_client_pd enable prefix prefix1
Command: config ipif System dhcpv6_client_pd enable prefix_name prefix1
Success.
DGS-3420-28SC:admin#
To configure the IPv6 address for IP2 interface:
DGS-3420-28SC:admin#config ipif ip2 ipv6 ipv6address prefix_name alpha 2:2:2::1/64
Command: config ipif ip2 ipv6 ipv6address prefix_name alpha 2:2:2::1/64
Success.
DGS-3420-28SC:admin#
11-2

create ipif

Description
This command is used to create an L3 interface. This interface can be configured with IPv4 or IPv6
addresses. Currently, it has a restriction: an interface can have only one IPv4 address defined. But it
can have multiple IPv6 addresses defined. Thus, the multinetting configuration of IPv4 must be done
through creation of a secondary interface on the same VLAN, instead of directly configuring multiple
169