D-Link xStack DGS-3420 Series Reference Manual page 812

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
beginning and end of the port list range are separated by a dash.
all - Specify that the command applies to all ports on the switch.
<priority 0-7> - Specify a priority value (0 to 7) to assign to untagged packets received by the switch
or a range of ports on the switch.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure an 802.1p default priority settings of 5 on all Switch ports:
DGS-3420-28SC:admin#config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
DGS-3420-28SC:admin#
5-12 show 802.1p default_priority
Description
This command is used to display the current default priority settings on the switch. The default priority
can also be assigned by the RADIUS server through the authentication process. Authentication with
the RADIUS server can be either per port or per user. For per port authentication, the priority assigned
by the RADIUS server will be the default priority of the effective port. For per user authentication, the
priority assigned by RADIUS will not be the effective port default priority, as the will priority associated
with MAC address will be assigned. Note that only devices supporting MAC-based VLANs can provide
per user authentication.
Format
show 802.1p default_priority {<portlist>}
Parameters
<portlist> - (Optional) Specify a range of ports to be displayed.
Note: If no parameter is specified, the system will display all ports with 802.1p default
priority.
Restrictions
None.
807