Show Snmp - D-Link xStack DGS-3420 Series Reference Manual
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
62-3
show snmp
Description
This command is used to display SNMP status.
Format
show snmp
Parameters
None.
Restrictions
None.
Example
To display SNMP:
DGS-3420-28SC:admin#show snmp
Command: show snmp
System Name
System Location
System Contact
SNMP Trap
SNMP State
SNMP Response Broadcast Request
DGS-3420-28SC:admin#
62-4
create trusted_host
Description
This command is used to create the trusted host. The switch allows you to specify up to 30 IP
addresses (or IP ranges) that are allowed to manage the switch via in-band SNMP or Telnet based
management software. These IP addresses must be members of the Management VLAN. If no IP
addresses are specified, then there is nothing to prevent any IP address from accessing the switch,
provided the user knows the Username and Password.
Format
create trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] {snmp | telnet | ssh | http | https | ping}
:
:
:
: Enabled
: Disabled
: Disable
692
Advertisement
Table of Contents
