Show Snmp Engineid; Create Snmp Group - D-Link xStack DGS-3420 Series Reference Manual
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To configure an identifier for the SNMP engine on the switch:
DGS-3420-28SC:admin#config snmp engineID 1023457890
Command: config snmp engineID 1023457890
Success.
DGS-3420-28SC:admin#
15-13 show snmp engineID
Description
This command is used to display the identification of the SNMP engine on the switch.
Format
show snmp engineID
Parameters
None.
Restrictions
None.
Example
To display the identification of an SNMP engine:
DGS-3420-28SC:admin#show snmp engineID
Command: show snmp engineID
SNMP Engine ID : 1023457890
DGS-3420-28SC:admin#
15-14 create snmp group
Description
This command is used to create a new SNMP group.
888
Advertisement
Table of Contents
