Config Rmon Trap - D-Link xStack DGS-3420 Series Reference Manual
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
62-22 show trap source_ipif
Description
This command is used to display the trap source IP interface.
Format
show trap source_ipif
Parameters
None.
Restrictions
None.
Example
To display the trap source IP interface:
DGS-3420-28SC:admin#show trap source_ipif
Command: show trap source_ipif
Trap Source IP Interface Configuration:
IP Interface
IPv4 Address
IPv6 Address
DGS-3420-28SC:admin#
62-23 config rmon trap
Description
This command is used to configure the trap state for RMON events.
Format
config rmon trap {rising_alarm [enable | disable] | falling_alarm [enable | disable]}
Parameters
rising_alarm - (Optional) Specify the trap state for rising alarm. The default state is enabled.
enable - Enable the trap state for rising alarm.
disable - Disable the trap state for rising alarm.
: ipif4
: None
: 3000::52
706
Advertisement
Table of Contents
