D-Link xStack DGS-3420 Series Reference Manual page 495

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Format
show ip_tunnel {<tunnel_name 12>}
Parameters
<tunnel_name 12> - (Optional) Enter the IP tunnel interface name used here. This name can be
up to 12 characters long.
Restrictions
None.
Example
To show an IP tunnel interface's information (Tunnel name is "tn2"):
DGS-3420-28SC:admin# show ip_tunnel tn2
Command: show ip_tunnel tn2
Tunnel Interface
Interface Admin State
Tunnel Mode
IPv6 Global Unicast Address : 2000::1/64
Tunnel Source
Tunnel Destination
DGS-3420-28SC:admin#
42-7 enable ip_tunnel
Description
This command is used to enable a single specified IP tunnel or all IP tunnels on the Switch.
Format
enable ip_tunnel {<tunnel_name 12>}
Parameters
<tunnel_name 12> - (Optional) Enter the IP tunnel interface name used here. This name can be
up to 12 characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
: tn2
: Enabled
: Manual
: 1.0.0.1
: 1.0.0.2
490