Table of Contents
Advertisement
2.
3.
Maintenance Settings
This section describes how to restore the camera to its factory default settings, how to manage
your configuration files, and how to upgrade the camera firmware.
Restoring Factory Defaults
You can either restore all the factory default settings, or all the factory default settings except for
the network settings. You can also reboot the system without restoring default settings.
To restore all factory default settings, including the network settings:
1.
2.
In the All files stored at field, either type the folder pathway into the field or click Select to
browse for, select and save the file location.
Click Save to save the file location displayed in the All files stored at field.
Note
There is also a Factory Default button on the bottom panel of the PTZ. Press this
button to restore factory default settings. See
information.
Navigate to System
Factory Default (see
Click Set Default.
All changes are lost and the system restarts after 100 seconds. The camera's IP address is
reset to the default setting.
Configuring System Settings | 111
Table 2-3
on
page 25
Figure
7-18).
800-11873V2 - A - 07/2013
for more
Advertisement
Table of Contents
