Table of Contents
Advertisement
Figure 6-17
Network Failure Detection Options
2.
Under Detection Switch, select On to enable the network failure detection function.
3.
Under Detection Type, enter the IP address you want to ping in the Ping the IP address
field. Enter how often to ping the IP address in the every [number] seconds field.
The every [number] seconds field should be set from 5 to 120 seconds. The default
setting is 30 seconds.
Note
Honeywell recommends that you enter the IP address of the local recording
device (DVR, NVR, and/or VMS system) which is used for local hard disk
recording. This way, if the Network Failure Detection function detects a network
failure with the local recording device, the camera can take an action such as
recording to the Micro SDHC card to compensate.
4.
Under Triggered Action, do one or more of the following actions to perform when a
network failure is detected:
•
Select one or both of the Enable alarm output 1 and Enable alarm output 2 check
boxes to enable that alarm relay output.
•
Select the Send message by FTP check box to send a network failure message to an
FTP server that you have configured (see
on setting up an FTP server).
•
Select the Send message by E-Mail check box to send a network failure message to
an email server that you have configured (see
information on setting up an email server).
•
Select Record stream to sd card to send images to a Micro SDHC card that you
have configured.
a.
In the Pre-trigger buffer field, enter the number of seconds of video to record
before the trigger occurs (from 1 to 9999).
b.
To continue to upload images for a specified period of time or until the alarm
ends, choose the option that fits your requirements from the following selections:
•
Select Upload for [number] sec and enter a time from 1 to 9999 seconds.
•
Select Upload during trigger active.
Configuring Alarms | 89
Server Settings on page 75
Server Settings on page 75
800-11873V2 - A - 07/2013
for information
for
Advertisement
Table of Contents
